All Paver Services All Concrete Services Pavers — Ocoee Pavers — Winter Garden Concrete — Ocoee Concrete — Winter Garden Our 38-Point Process Warranty About Blog Contact Call: (689) 356-6292
Locally owned in Ocoee, FL · Since 2020

Concrete Driveway Installation
Central Florida

Poured concrete driveways with 4,000 PSI mix, proper rebar reinforcement, and engineered control joint spacing. The most affordable durable driveway option for Florida.

✓ 38-Point Process✓ 2-Year Warranty✓ Free Estimate✓ 12 Cities Served
Why Concrete

When concrete is the right driveway choice

A poured concrete driveway is the most cost-effective durable driveway option in Central Florida. It costs roughly half what pavers cost upfront, lasts 15-25 years with proper installation, handles any vehicle load (including RVs, work trucks, and boats), and can be finished in multiple ways (broom, smooth, stamped, exposed aggregate, stained).

Concrete works particularly well when budget is the primary constraint, when you'll be parking heavy vehicles long-term, or when the driveway is being installed alongside other concrete work (sidewalks, garage floor, patio) and we can use a single concrete pour to save mobilization cost.

Concrete vs pavers — the honest comparison

Upfront cost: concrete wins by 40-50%. Long-term cost over 30 years: pavers usually win because concrete will crack and may need replacement at 20-25 years. Appearance: pavers offer more design options and look more premium. Maintenance: concrete needs no annual maintenance; pavers need occasional joint sand refresh. Choice depends on budget, timeline, and aesthetic priorities.

What separates a good concrete driveway from a bad one

Most concrete driveways fail prematurely because of three skipped steps: under-spec mix (3,000 PSI instead of 4,000 PSI), inadequate rebar reinforcement (or fiber-only with no rebar), and poor control joint placement (joints too far apart or too shallow). All three are invisible on day 1. The driveway looks identical to a properly installed one. Failure starts at year 5-8 with cracks where the joints should have been.

Florida-specific considerations

Central Florida's heat-and-rain cycle stresses concrete more than colder climates. We use a higher minimum PSI rating (4,000 vs the 3,000 minimum), include fiber mesh as additional crack control, and space control joints at 8-10 feet (vs 12-15 feet common in milder climates).

Pricing 2026

How much does a concrete driveway cost in 2026?

A concrete driveway in our area typically costs $10–$13 per square foot installed in 2026 with our standard 4,000 psi, fiber-reinforced, broom-finish mix — about $6,000–$7,800 for a 600 sq ft two-car driveway. Removing an old driveway adds $1.50–$3.50 per square foot.

Mix and finishPer sq ft400 sq ft600 sq ft900 sq ft
3,000 psi, broom finish (budget)$8–$10$3,200–$4,000$4,800–$6,000$7,200–$9,000
4,000 psi + fiber, broom finish (our standard)$10–$13$4,000–$5,200$6,000–$7,800$9,000–$11,700
Exposed aggregate$13–$17$5,200–$6,800$7,800–$10,200$11,700–$15,300
Stamped and colored$15–$22$6,000–$8,800$9,000–$13,200$13,500–$19,800
5,000 psi with rebar (RVs, boats, trucks)$14–$18$5,600–$7,200$8,400–$10,800$12,600–$16,200
💰What moves the priceUp: tearing out the old driveway, extra thickness or rebar for heavy vehicles, decorative finishes, long or sloped driveways that need more than one pour, drainage fixes. Down: simple rectangular layouts, good truck access, standard broom finish. Every number on this site comes from the same price sheet — see the Orlando-area concrete cost guide.
Installation Standards

How we install concrete driveways

  1. Excavate to 4-6 inches below finished grade depending on driveway thickness
  2. Install woven geotextile fabric over native soil to prevent base migration
  3. Place and compact 4 inches of crushed limerock base (95% Standard Proctor density)
  4. Install perimeter forms with proper slope (1-2% pitch away from house and garage)
  5. Lay rebar grid: #4 (1/2 inch) rebar at 18-inch spacing both directions, supported on chairs above base
  6. Add fiber mesh to concrete mix at batch plant (additional crack control)
  7. Pour 4,000 PSI concrete at minimum 4-inch slab thickness (5-6 inches for truck/RV loads)
  8. Screed and float surface to specified finish (broom, smooth, stamped, or exposed)
  9. Cut control joints at 8-10 foot spacing while concrete is still green (1/4 of slab depth)
  10. Apply curing compound to retain moisture during initial 7-day cure
  11. Apply edge sealing where slab meets garage, sidewalk, or street to prevent water intrusion
  12. Allow 7 days for vehicle traffic, 28 days for full design strength
Frequently Asked Questions

Concrete Driveway Installation FAQ

How much does a concrete driveway cost in Central Florida?

Most concrete driveways in our area cost $10–$13 per square foot installed in 2026 with a 4,000 psi, fiber-reinforced broom finish — about $6,000–$7,800 for 600 sq ft. Exposed aggregate runs $13–$17 and stamped $15–$22 per square foot; removing an old driveway adds $1.50–$3.50 per square foot.

How long does concrete driveway installation take?

Demolition of existing driveway: 1 day. Base prep and forms: 1-2 days. Pour day: 1 day. Initial cure (walkable): 24 hours. Vehicle-driveable: 7 days. Total from start to driving: 4-5 working days.

How thick should a concrete driveway be?

Standard residential (passenger vehicles): 4 inches with rebar grid. Trucks/heavy vehicles/RVs: 5-6 inches. Commercial driveways: 6-8 inches. The thickness affects load capacity and longevity significantly.

Will the concrete crack?

All concrete eventually develops hairline cracks (under 1/16 inch). With proper control joints every 8-10 feet, 4,000 PSI mix, rebar grid, and fiber reinforcement, hairline cracks stay minor and won't compromise the driveway for 15-20+ years. Major cracking within 5 years usually indicates installation problems.

Do I need a permit for a concrete driveway?

Most Central Florida jurisdictions require a permit for new driveway installation. Replacement in the same footprint sometimes doesn't. We handle permit applications as part of the project.

Can you pour concrete over my existing driveway?

Yes — overlay pours are possible if the existing concrete is structurally sound. The overlay is typically 2-3 inches and bonded with a slurry bonding agent. Cost is roughly 60-70% of a new pour.

How long until I can drive on the new concrete?

Walk on it after about 24 hours and drive a car on it after about 7 days. Keep heavy trucks, RVs and trailers off until about 28 days, when the concrete reaches its design strength. More in our new concrete curing guide.

What's the difference between 3,000 and 4,000 PSI concrete?

PSI is the compressive strength rating. 3,000 PSI is the residential code minimum; 4,000 PSI has 33% more cement and significantly better long-term durability in Florida heat. We pour 4,000 PSI as our standard.

Service Area

Available in all 12 cities we serve

Same crew, same concrete driveway installation standards, same warranty across every Central Florida city we serve.

Free Concrete Driveway Estimate

Same-day response · 7 days a week · No obligation

(689) 356-6292
Free Estimate Form